Step 1
Specify frequency and wire material.

Step 2
Enter coil and leads dimensions

Step 3
Read coil inductance, distributed C, self-resonant frequency, and Q factor.

Step 4
If desired, insert the coil's equivalent circuit(s) as a load in your model.

.

Step 1
Specify frequency and wire material.

Home | Features | 3D Field Patterns | 2D Field Patterns | Graphs | Symbols | Data Good Indicators | Coil Wizard | Clamp Wizard | Match Wizard

ANTENNA MODEL is a trademark of Teri Software Company.
Microsoft, Windows, and Windows NT are registered trademarks of Microsoft Corporation.

This page was last updated 07/22/08
Copyright © 2001-2008 Teri Software Company. All rights reserved.